JVC CA-FSP5, SP-UXP5 manual Specifications

Page 25

Specifications

Design and specifications are subject to change without notice.

FS-P5 (CA-FSP5 and SP-UXP5)

Amplifier

Output Power

50 W per channel, min. RMS, driven into 6 Ω at 1 kHz with no more than 10 % total harmonic distortion.

Audio input sensitivity/Impedance (at 1 kHz)

AUX:	400 mV/48 kΩ
Audio output level	260 mV/5.8 kΩ
AUX:	260 mV/5.8 kΩ
Digital output — OPTICAL DIGITAL OUT
Signal wave length:	660 nm
Output level:	–21 dBm to –15 dBm
Speakers/Impedance	6 Ω – 16Ω

Cassette deck

Frequency response
Normal (type I):	50 Hz – 14 000 Hz
Wow and flutter	0.15 % (WRMS)

General

Power requirement	AC 120 V , 60 Hz
Power consumption	85 W (at operation)
	5.8 W (on standby)
Dimensions (approx.)	505 mm x 256 mm x 295 mm (W/H/D)
	(20 1/8 in. x 10 1/8 in. x 11 5/8 in.)
Mass (approx.)	10.0 kg (22.1 lbs)

Tuner

FM tuning range	87.5 MHz – 108.0 MHz
AM tuning range	530 kHz – 1 710 kHz

CD player

Dynamic range	85 dB
Signal-to-noise ratio	90 dB
Wow and flutter	Immeasurable

Supplied Accessories

	See page 6.
Speaker
Speaker units	Woofer 12 cm (4 3/4 in.) cone x 1
	Tweeter 4 cm (1 5/8 in.) cone x 1
Impedance	6 Ω
Dimensions (approx.)	160 mm x 256 mm x 213 mm (W/H/D)
	(6 5/16 in. x 10 1/8 in. x 8 7/16 in.)
Mass (approx.)	2.3 kg (5.1 lbs)

– 22 –

Image 25

Contents Compact Component System Mises en garde, précautions et indications diverses Instructions for safe use Introduction PrecautionsAbout This Manual Contents Front Panel Location of the Buttons and ControlsFront Panel Become familiar with the buttons and controls on your unitFront Panel Display Window Display WindowRemote Control Remote ControlGetting Started Supplied Accessories Connecting AntennasTurn the AM loop antenna until you have the best reception Connecting SpeakersRelease the finger from the clamp AM antennaBy using audio cords not supplied, connect Connecting Other EquipmentTo remove the speaker grilles To connect audio equipmentSetting the Clock Turning On the PowerCommon Operations Selecting the Sources and Starting PlaySelecting the Display Brightness Adjusting the VolumeReinforcing the Bass Sound Selecting the Sound ModesPresetting Stations Tuning in a StationTuning in a Preset Station Listening to FM and AM BroadcastsPlaying Back the Entire CD Normal Play Playing Back CDs CD/CD-R/CD-RWBasic CD Operations Press CD 3/8Program Play On the remote control only Load a CDPress Prog program Repeat to program other tracks youProhibiting Disc Ejection Tray Lock Playing at Random Random PlayRepeating Tracks Repeat Play On the unit onlyPlaying Back Tapes To play both sides Reverse ModePlaying Back a Tape Press 0for cassette deckRecording on a Tape RecordingCheck the recording direction for the tape Press RECOne Track Recording CD Direct RecordingRepeat steps 2 and 3 to record other tracks you want To stop CD Direct Recording, press 7. The tape stops afterUsing Daily Timer and Recording Timer Using the TimersOn the remote control only Press Sleep Using Sleep TimerHow Sleep Timer actually works Wait for about 5 seconds after specifying the time lengthSymptom TroubleshootingCleaning the unit MaintenanceHandling discs Handling cassette tapesSpecifications Authorized Service Centers Limited Warranty 0401MWMMDWJEM