JVC SP-UXP5, CA-FSP5 manual Mises en garde, précautions et indications diverses

Page 2

Warnings, Cautions and Others

Mises en garde, précautions et indications diverses

 

 

CAUTION

 

 

 

RISK OF ELECTRIC SHOCK

 

 

 

DO NOT OPEN

 

 

 

 

 

 

 

 

 

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK,

 

DO NOT REMOVE COVER (OR BACK).

 

NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

For U.S.A.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1.Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture.

ATTENTION

Afin d’éviter tout risque d’électrocution, d’incendie, etc.:

1.Ne pas enlever les vis ni les panneaux et ne pas ouvrir le coffret de l’appareil.

2.Ne pas exposer l’appareil à la pluie ni à l’humidité.

Caution –– STANDBY/ON button! Disconnect the mains plug to shut the power off completely (the STANDBY/ON lamp goes off).

The STANDBY/ON button in any position does not disconnect the mains line.

When the unit is on standby, the STANDBY/ON lamp lights red.

When the unit is turned on, the STANDBY/ON lamp lights green.

The power can be remote controlled.

Attention –– Commutateur STANDBY/ON!

Déconnectez la prise d’alimentation secteur pour mettre l’appareil complètement hors tension (le témoin STANDBY/ ON s’éteint).

L’interrupteur STANDBY/ON, sur n’importe quelle position, ne peut pas déconnecter l’appareil du secteur.

Quand l’appareil est en mode de veille, le témoin STANDBY/ON est allumé en rouge.

Quand l’appareil est sous tension, le témoin STANDBY/ON est allumé en vert.

L’alimentation peut être télécommandée.

For Canada/pour le Canada

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQUAU FOND.

For Canada/pour le Canada

THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS AS SET OUT IN THE INTERFERENCE-CAUSING EQUIPMENT STANDARD ENTITLED “DIGITAL APPARATUS,” ICES-003 OF THE DEPARTMENT OF COMMUNICATIONS.

CET APPAREIL NUMERIQUE RESPECTE LES LIMITES DE BRUITS RADIOELECTRIQUES APPLICABLES AUX APPAREILS NUMERIQUES DE CLASSE B PRESCRITES DANS LA NORME SUR LE MATERIEL BROUILLEUR: “APPAREILS NUMERIQUES”, NMB-003 EDICTEE PAR LE MINISTRE DES COMMUNICATIONS.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular,

specifies that the cable ground shall be connected to the

grounding system of the building, as close to the point of cable entry as practical.

1.CLASS 1 LASER PRODUCT

2.CAUTION: Invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam.

3.CAUTION: Do not open the top cover. There are no user serviceable parts inside the Unit; leave all servicing to qualified service personnel.

1.PRODUIT LASER CLASSE 1

2.ATTENTION: Radiation laser invisible quand l'appareil est ouvert ou que le verrouillage est en panne ou désactivé. Eviter une exposition directe au rayon.

3.ATTENTION: Ne pas ouvrir le couvercle du dessus. Il n'y a aucune pièce utilisable à l'intérieur. Laisser à un personnel qualifié le soin de réparer votre appareil.

G-1

Image 2
Contents Compact Component System Mises en garde, précautions et indications diverses Instructions for safe use About This Manual PrecautionsIntroduction Contents Front Panel Location of the Buttons and ControlsFront Panel Become familiar with the buttons and controls on your unitDisplay Window Front Panel Display WindowRemote Control Remote ControlSupplied Accessories Connecting Antennas Getting StartedRelease the finger from the clamp Connecting SpeakersTurn the AM loop antenna until you have the best reception AM antennaTo remove the speaker grilles Connecting Other EquipmentBy using audio cords not supplied, connect To connect audio equipmentCommon Operations Turning On the PowerSetting the Clock Selecting the Sources and Starting PlayReinforcing the Bass Sound Adjusting the VolumeSelecting the Display Brightness Selecting the Sound ModesTuning in a Preset Station Tuning in a StationPresetting Stations Listening to FM and AM BroadcastsBasic CD Operations Playing Back CDs CD/CD-R/CD-RWPlaying Back the Entire CD Normal Play Press CD 3/8Press Prog program On the remote control only Load a CDProgram Play Repeat to program other tracks youRepeating Tracks Repeat Play Playing at Random Random PlayProhibiting Disc Ejection Tray Lock On the unit onlyPlaying Back a Tape To play both sides Reverse ModePlaying Back Tapes Press 0for cassette deckCheck the recording direction for the tape RecordingRecording on a Tape Press RECRepeat steps 2 and 3 to record other tracks you want CD Direct RecordingOne Track Recording To stop CD Direct Recording, press 7. The tape stops afterUsing the Timers Using Daily Timer and Recording TimerHow Sleep Timer actually works Using Sleep TimerOn the remote control only Press Sleep Wait for about 5 seconds after specifying the time lengthTroubleshooting SymptomHandling discs MaintenanceCleaning the unit Handling cassette tapesSpecifications Authorized Service Centers Limited Warranty 0401MWMMDWJEM