JVC CA-FSP5 Connecting Other Equipment, To remove the speaker grilles, To connect audio equipment

Page 11

To remove the speaker grilles

The speaker grilles are removed as the illustrations below.

HolesProjections

Speaker grille

To remove the speaker grille, inserting your fingers at the top of the speaker grille, pull towards you. Then pull the bottom towards you.

To attach the speaker grille, put the projections of the speaker grille into the holes of the speaker.

To connect audio equipment with an optical digital input terminal

You can record CD sound onto the connected digital equipment.

Protective plug

OPTICAL

DIGITAL

OUT

Before connecting the other equipment, remove the protective plug from the terminal.

		Audio equipment
		with an optical digital
To optical digital input		input

Connect an optical digital cord (not supplied) between the optical digital input terminal on the other equipment and the OPTICAL DIGITAL OUT terminal.

Connecting Other Equipment

You can connect both of the analog and digital equipment.

•DO NOT connect any equipment while the power is on.

•DO NOT plug in any equipment until all connections are complete.

To connect audio equipment

Be sure that the plugs of the audio cords are colored: White plugs and jacks are for left audio signals, and red ones for right audio signals.

	OUT
AUX R	L
	IN

To audio output

Audio equipment

To audio input

By using audio cords (not supplied), connect:

•Between the audio input jacks on the other equipment and AUX OUT jacks: For recording on the other equipment.

•Between the audio output jacks on the other equipment and AUX IN jacks: For playing the other equipment.

Now, you can plug the AC power cord.

IMPORTANT: Be sure to check all connections to be done before plugging the AC power cord into a wall outlet.

– 8 –

Image 11

Contents Compact Component System Mises en garde, précautions et indications diverses Instructions for safe use About This Manual PrecautionsIntroduction Contents Become familiar with the buttons and controls on your unit Location of the Buttons and ControlsFront Panel Front PanelFront Panel Display Window Display WindowRemote Control Remote ControlGetting Started Supplied Accessories Connecting AntennasAM antenna Connecting SpeakersTurn the AM loop antenna until you have the best reception Release the finger from the clampTo connect audio equipment Connecting Other EquipmentBy using audio cords not supplied, connect To remove the speaker grillesSelecting the Sources and Starting Play Turning On the PowerSetting the Clock Common OperationsSelecting the Sound Modes Adjusting the VolumeSelecting the Display Brightness Reinforcing the Bass SoundListening to FM and AM Broadcasts Tuning in a StationPresetting Stations Tuning in a Preset StationPress CD 3/8 Playing Back CDs CD/CD-R/CD-RWPlaying Back the Entire CD Normal Play Basic CD OperationsRepeat to program other tracks you On the remote control only Load a CDProgram Play Press Prog programOn the unit only Playing at Random Random PlayProhibiting Disc Ejection Tray Lock Repeating Tracks Repeat PlayPress 0for cassette deck To play both sides Reverse ModePlaying Back Tapes Playing Back a TapePress REC RecordingRecording on a Tape Check the recording direction for the tapeTo stop CD Direct Recording, press 7. The tape stops after CD Direct RecordingOne Track Recording Repeat steps 2 and 3 to record other tracks you wantUsing Daily Timer and Recording Timer Using the TimersWait for about 5 seconds after specifying the time length Using Sleep TimerOn the remote control only Press Sleep How Sleep Timer actually worksSymptom TroubleshootingHandling cassette tapes MaintenanceCleaning the unit Handling discsSpecifications Authorized Service Centers Limited Warranty 0401MWMMDWJEM