Juniper Networks SSG 20 manual Connecting Interface Cables to a Device, Connecting the Power

SSG 20 Hardware Installation and Configuration Guide

To desk-mount an SSG 20 device, perform the following steps:

Figure 9: SSG 20 Desk-mount

1.Attach the desktop stand to the side of the device. We recommend using the side closest to the power adapter.

2.Place the mounted device on the desktop.

3.Plug in the power adapter and connect the power supply to the power outlet.

Connecting Interface Cables to a Device

To connect the interface cable to a device, perform the following steps:

1.Have ready a length of the type of cable used by the interface.

2.Insert the cable connector into the cable-connector port on the interface faceplate.

3.Arrange the cable as follows to prevent it from dislodging or developing stress points:

a.Secure the cable so that it is not supporting its own weight as it hangs to the floor.

b.Place any excess cable out of the way in a neatly coiled loop.

c.Use fasteners to maintain the shape of the cable loops.

Connecting the Power

To connect the power to a device, perform the following steps:

1.Plug the DC-connector end of the power cable into the DC-power receptacle on the back of the device.

2.Plug the AC-adapter end of the power cable into an AC-power source.

WARNING: We recommend using a surge protector for the power connection.

22„ Connecting Interface Cables to a Device