SSG 20 Hardware Installation and Configuration Guide
Table 19: Fields in E1 Physical Layer Tab Window
Field | Description |
|
|
Clocking | Sets the transmit clock on the interface. |
|
|
Frame Checksum | Sets the size of checksum. Default is 16. |
|
|
Framing Mode | Sets the framing format. Default is without CRC4. |
|
|
Idle Cycles Flag | Sets the value that the interface transmits during idle cycles. Default |
| setting is 0x7E: |
| 0x7E (flags) |
| 0xFF (ones) |
|
|
Start/End Flags | Sets the transmission of start and end flags to either filler or shared. |
| The default is filler. |
|
|
Invert Data checkbox | Enables inverted transmission of unused data bits. |
|
|
Time Slots | Sets the use of time slots on a T1 interface. Default is 0, all 32 time |
| slots used. |
|
|
Figure 35: E1 Frame Relay Tab Window
Table 20: Fields in E1 Frame Relay Tab Window
Field | Description |
|
|
Enables | |
|
|
Type | Sets the frame relay LMI type: |
| ANSI: American National Standards Institute supports data rates |
| up to 8Mbps downstream and 1Mbps upstream. |
| ITU: International Telecommunications Union supports data |
| rates of 6.144 Mbps downstream and 640 kbps upstream. |
|
|
Interface Name | Sets the subinterface name. |
|
|
Inverse ARP checkbox | Enables inverse Address Resolution Protocol (ARP) for the |
| subinterface. |
|
|
Frame Relay DLCI | Assigns a DLCI to the subinterface. |
74
