Front Panel
This section describes the following elements on the front panel of an SSG 20 device:
System Status LEDs
Port Descriptions
Mini Physical Interface Module Port Descriptions
System Status LEDs
The system status LEDs display information about critical device functions. Figure 3 illustrates the position of each status LED on the front of the SSG
Figure 3: Status LEDs
|
| 1 |
POWER | PIM 1 | 802. 11a |
STATUS | PIM 2 | b/g |
|
| WLAN |
2
When the system powers up, the POWER LED changes from off to blinking green, and the STATUS LED changes in the following sequence: red, green, blinking green. Startup takes approximately two minutes to complete. If you want to turn the system off and on again, we recommend you wait a few seconds between shutting it down and powering it back up. Table 2 provides the name, color, status, and description of each system status LED.
Table 2: Status LED Descriptions
Name | Color | Status | Description |
|
|
|
|
POWER | Green | On steadily | Indicates that the system is receiving power. |
|
|
|
|
|
| Off | Indicates that the system is not receiving |
|
|
| power. |
|
|
|
|
| Red | On steadily | Indicates that the device is not operating |
|
|
| normally. |
|
|
|
|
|
| Off | Indicates that the device is operating |
|
|
| normally. |
|
|
|
|
STATUS | Green | On steadily | Indicates that the system is starting or |
|
|
| performing diagnostics. |
|
|
|
|
|
| Blinking | Indicates that the device is operating |
|
|
| normally. |
|
|
|
|
| Red | Blinking | Indicates that there is an error detected. |
|
|
|
|
PIM 1 | Green | On steadily | Indicates that the mini PIM is functioning. |
|
|
|
|
|
| Blinking | Indicates that the mini PIM is passing traffic. |
|
|
|
|
|
| Off | Indicates that the mini PIM is not |
|
|
| operational. |
Front Panel 11
