4.Refer to drawing 4a. Make sure that the tab on the Right Foam Grip (75) is inserted into the slot between the post and the Console Base (82).
Refer to drawing 4b. Make sure that the front edge of the Right Foam Grip (75) is under the Console Base (82) as shown. Tighten one of the two Foam Grip Screws (33) into the side of the Right Foam Grip as shown. Note: It may be necessary to pull the Right Foam Grip outward (see arrow A) to align the Screw with the hole in the post.
Attach the other Handrail Extension and the Left Foam Grip (not shown) as described in step 3 and this step.
4a | 82 |
| 4b |
|
| Post |
|
|
| 75 | A 82 |
|
|
| |
| Tab |
| 33 |
|
|
| 75 |
5.Press the Lock Knob Sleeve (70) into the left Upright (69). If necessary, use a rubber mallet to tap the Lock Knob Sleeve into the Upright.
Make sure that the Lock Pin Collar (72) and the Spring (71) are on the Lock Pin (74). (Note: If there are two Lock Pin Collars, place one on each side of the Spring.) Insert the Lock Pin into the left Upright (69) and tighten the Lock Knob (68) onto the Lock Pin.
5 |
|
68 |
|
| 69 |
| 71 |
| 72 |
70 | 74 |
6.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet from damage, place a mat under the treadmill.
7