Reebok Fitness RBTL09500 Driver and rubber mallet, Extension Legs 102 remain in the Uprights

Assembly

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires your own Phillips screw-

driver and rubber mallet .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1.With the help of a second person, carefully raise the Uprights (69) until the treadmill is in the position shown.

Insert one of the Extension Legs (102) into the treadmill as shown. Make sure that the Extension Leg is turned so the Base Pad (99) is on the bottom. Note: It may be help- ful to tip the Uprights (69) forward as you insert the Extension Leg.

Insert the other Extension Leg (not shown) in the same way.

2.With the help of a second person, carefully tip the Uprights (69) down as shown. Make sure that the

Extension Legs (102) remain in the Uprights.

Attach each Extension Leg (102) with two of the four 3/4Ó Screws (100). If there are square rubber bumpers on the bottom of the Uprights (69), remove them.

With the help of a second person, carefully tip the Uprights (69) back to the vertical position.

Note: One replacement Base Pad (99) may be included. If a Base Pad becomes worn and needs to be replaced, use the replacement Base Pad.

3.Remove the Handrail Extension (66) from the Right Foam Grip (75), which has a large cutout in the left side. Insert the Handrail Extension into the post on the right Upright (69) as shown. Note: Be careful not to pinch the wires in the Upright. Make sure the wires in the post are cen- tered. Align the holes in the Handrail Extension with the holes in the post. If necessary, tap the Handrail Extension with a rubber mallet to fully insert it. Next, attach the Handrail Extension by tightening two Small Screws (67) into the indicated holes.

Slide the Right Foam Grip (75) as far as possible onto the post on the right Upright (69). It may be helpful to apply soapy water to the Handrail Extension (66).

1
	69
	102
	99
2
	99
69	69
110
	100
	102
99	100
	102
3
	67
Cutout	66
75	69
	Post
	Wires

6