If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the receiver included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated Screws (87) from the back of the Console Base (88).
1 |
88 |
87 |
2.Connect the Short Jumper Wire (A) to the wire on the Receiver (B). Connect the other end of the Jumper Wire to the PULSE jack on the back of the Console (see draw- ing 2b). Next, peel the paper off the pad on the bottom of the Receiver (B). Turn the Receiver so the cylinder is on the side shown, and press the Receiver into the bot- tom of the Console Base (81) in the location indicated by the dotted line. Note: The included Long Jumper Wire is not needed and can be discarded.
Make sure that no wires are pinched. Reattach the back of the Console Base (88) with the Screws (87) (see step 1 above).
2a | 81 | 2b |
|
| PULSE |
|
| Jack |
| A |
|
| Cylinder |
|
| B |
|
8