M1001 6" x 26" Vertical Mill
OPERATIONS
General
The Model M1001 will perform many types of operations that are beyond the scope of this manual. Many of these operations can be dangerous or deadly if performed incor- rectly.
The instructions in this section are written with the under- standing that the operator has the necessary knowledge and skills to operate this machine. If at any time you are experiencing difficulties performing any operation, stop using the machine!
If you are an inexperienced operator, we strongly recom- mend that you read books, trade articles, or seek training from an experienced vertical mill operator before per- forming any unfamiliar operations. Above all, your safety should come first!
READ and understand this entire instruc- tion manual before using this machine. Serious personal injury may occur if safety and operational information is not understood and followed. DO NOT risk your safety by not reading!
OPERATIONS
Positioning Spindle Head
The spindle head can be rotated vertically 45˚ both ways, and can rotate horizontally on the column 45˚ in both directions.
To rotate the spindle head vertically, do these steps:
1.Unplug the mill!
2.Make sure the spindle is stopped and the work area is free from obstructions before proceeding.
3.Loosen the four nuts that lock the headstock in place with a 17mm wrench (see Figure 14 on next page).
4.Rotate the headstock to the desired angle.
5.Tighten the spindle locking nuts.
Note: Additional setup tools should be used to determine the precise angle of the spindle head.
Always wear safety glasses when oper- ating the mill. Failure to comply may result in serious personal injury.
DO NOT investigate problems or adjust the mill while it is running. Wait until the machine is turned off, unplugged and all working parts have come to a complete stop before proceeding!