Epic Fitness EPTL22310.0 manual Top, Problem The walking belt slows when walked on

Next, locate the Reed Switch (48) and the Magnet

Top

(101) on the left side of the Pulley (54). Turn the

Pulley until the Magnet is aligned with the Reed

View

Switch. Make sure that the gap between the

26

1/8 in.

Magnet and the Reed Switch is about 1/8 in. (3

mm). If necessary, loosen the indicated #8 x 3/4"

48

54

Washer Head Tek Screw (26), move the Reed Switch

slightly, and then retighten the Washer Head Tek

101

Screw. Reattach the Hood (not shown) with the six #8

x 3/4" Screws (not shown). Run the treadmill for a few

minutes to check for a correct speed reading.

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 13.

b. If the walking belt is overtightened, treadmill perfor-

b

3–4 in.

mance may decrease and the walking belt may be-

come damaged. Remove the key and UNPLUG THE

POWER CORD. Using the hex key, turn both idler

roller bolts counterclockwise, 1/4 of a turn. When the

walking belt is properly tightened, you should be able

to lift each edge of the walking belt 3 to 4 in. (8 to 10

cm) off the walking platform. Be careful to keep the

walking belt centered. Then, plug in the power cord,

insert the key, and run the treadmill for a few min-

Idler Roller Bolts

utes. Repeat until the walking belt is properly tight-

ened.