2.Identify the Right Upright (88). Have a second person hold the Right Upright near the Right Base Cover (111). See the inset drawing. Tie the wire tie in the Right Upright securely around the end of the Upright Wire (86). Then, pull the other end of the wire tie up through the Right Upright until the Upright Wire is routed through the Right Upright.
Gently pull up on the Upright Wire (86) as you set the Right Upright (88) on the Base (115) in- side the Right Base Cover (111). Be careful not to pinch the Upright Wire.
Attach the Right Upright (88) to the Base (115) with two 3/8" x 3 3/4" Patch Bolts (2) and two 3/8" Star Washers (8). Do not tighten the Patch Bolts yet. Note: It may be necessary to tip the top of the Right Upright forward slightly as you thread the Patch Bolts into the Right Upright.
3.Set the Left Upright (85) on the Base (115) in- side the Left Base Cover (81).
Attach the Left Upright (85) to the Base (115) with two 3/8" x 3 3/4" Patch Bolts (2) and two 3/8" Star Washers (8). Do not tighten the Patch Bolts yet. Note: It may be necessary to tip the top of the Left Upright forward slightly as you thread the Patch Bolts into the Left Upright. With the help of a second person, lower the treadmill off the cardboard stands. The stands will be used again in assembly step 9.
2 |
|
|
|
86 |
| 88 |
|
| Wire | 86 | |
| Tie | Wire | |
|
| Tie | |
88 |
|
|
|
| 115 |
|
|
111 | 8 |
|
|
| 2 |
|
|
3 |
|
|
|
| 85 | 115 | |
|
| ||
|
|
| 81 |
|
|
| 8 |
|
|
| 2 |
|
|
| Cardboard |
|
|
| Stands |
7 |
|
|
|