![](/images/new-backgrounds/1246216/24621613x1.webp)
2. Insert the Wire Harnesses (22, 82) into the right Upright | 2 |
|
| |
(99). |
|
| ||
Console |
|
| ||
|
|
| ||
Set the console assembly on the Uprights (99). While a | Assembly |
|
| |
|
|
| ||
second person holds the console assembly, attach it with |
|
|
| |
four Console Bolts (86) and four Console Washers (88) |
|
|
| |
as shown. Start all four Console Bolts and then firmly |
|
|
| |
tighten them. |
|
|
| |
| 22, 82 |
|
| |
| 88 | 88 |
| |
| 86 | 86 |
| |
| 99 |
|
| |
3. Insert a Wheel (93) into a Wheel Housing (43). Attach the | 3 |
|
| |
Wheel with a Wheel Bolt (92) and a Nut (25). Note: Do |
|
| ||
|
|
| ||
not overtighten the Nut; the Wheel should turn freely. |
| 99 |
| |
|
|
| ||
Tip the Uprights (99) forward slightly and insert the Wheel |
|
|
| |
Housing (43) into the base of the Uprights as shown. |
|
|
| |
Attach the other Wheel (not shown) and Wheel Housing |
|
|
| |
(not shown) as described above. | 25 |
|
| |
|
| 43 |
| |
| 93 | 92 |
| |
4. With the help of a second person, carefully lower the | 4 |
|
| |
Uprights (99). Make sure that the Wheel Housings (43) |
|
| ||
99 |
|
| ||
remain in the base of the Uprights. | 97 | 98 | ||
| ||||
|
|
| ||
Attach each Wheel Housing (43) with a 1” Tek Screw |
|
|
| |
(98). Next, attach the two Base Pads (97) to the base of |
|
|
| |
the Uprights (99) with 1” Tek Screws (98). |
|
|
| |
With the help of a second person, carefully raise the |
|
|
| |
Uprights (99) to the vertical position. |
|
| 98 | |
|
| 43 | ||
|
|
|
7