4.Position the Base (52) as close to the front of the treadmill as possible, as shown.
See the upper inset drawing. Locate the wire tie in the lower end of the Right Upright (54). Tie the wire tie securely around the end of the Wire Harness (39). Then, locate the other end of the wire tie in the upper end of the Right Upright. Pull the upper end of the wire tie until the Wire Harness extends from the upper end of the Right Upright. Secure the Wire Harness to the Right Upright so that it will not fall inside.
See the lower inset drawing. Press the indi- cated Grommet (49) into the Right Upright (54).
5.See the left inset drawing. Identify the two Frame Spacers (11). Open the included packet of grease, and apply grease to both sides of both Frame Spacers. Then, identify the outer side of each Frame Spacer.
Hold a Frame Spacer (11) between the Right Upright (54) and the Lift Frame (23), with the outer side of the Frame Spacer facing the Right Upright.
With the help of a second person, lift the front of the treadmill. Attach the Lift Frame (23) to the Right Upright (54) with an M10 x 60mm Patch Bolt (1), an M10 Flat Washer (14), and an M10 Star Washer (9); do not fully tighten the Patch
Bolt yet.
4 |
|
| 39 |
| 54 |
39 |
|
|
| ||
54 |
|
|
| Wire Tie | |
|
|
|
|
| |
|
|
|
|
| 54 |
52 |
|
| 49 |
|
|
5 |
|
|
|
|
|
|
|
| 54 |
|
|
|
| 11 | 9 | 14 | 1 |
| 23 |
|
|
| |
Grease |
|
|
|
| |
|
| Top View |
| ||
11 |
| 11 |
| 14 | 1 |
|
|
| 9 |
| |
|
| 23 |
|
| |
Outer Side |
|
|
| 54 |
|
|
|
|
|
| |
8