
12.Set the console assembly on the Left and Right Uprights (77, 92). Be careful not to pinch any wires.
Attach the console assembly to the Pulse Bar (90) with six #8 x 3/4" Screws (1). Start all six
Screws before firmly tightening any of them.
13.Identify the Right Handrail Cover (55), which is marked with a sticker. Slide the Right Handrail Cover onto the right Handrail (80).
Remove the paper backing off of the tape in the indicated location and press the Right Handrail Cover (55) against the console assembly.
Tighten a #8 x 1/2" Screw (2) into the Rightbe Handrail Cover and the Right Upright (92); careful not to overtighten the Screw. Attach the Left Handrail Cover (78) in the same way.
12 |
| Console Assembly |
| ||
| 921 | 90 | 1 | 1 | 77 |
|
| ||||
|
|
| |||
13 | Console |
|
|
|
|
| Assembly |
|
|
|
|
| Tape |
|
|
|
|
| 78 |
|
|
|
|
| 2 |
|
|
|
|
|
|
| Tape |
| |
|
|
| 80 | 55 | 292 |
|
|
|
|
|
14. Carefully lower the Uprights (77, 92) as shown. | 14 | Console Assembly | Start First | |
Start the two indicated #8 x 1 1/2" Screws (3) | ||||
into the Left and Right Uprights (77, 92) and the |
|
| 3 |
|
console assembly. If necessary, pull back on the |
|
|
| 77 |
console assembly slightly to align the holes in |
|
|
| |
the Uprights with those on the console assem- | Start |
|
|
|
bly. Start the other two #8 x 1 1/2" Screws (3) |
|
|
| |
and then tighten all four Screws; do not | First | 3 |
|
|
overtighten the Screws. Then, raise the |
|
|
| |
Uprights. |
| 92 |
|
|
See steps 4 and 6. Firmly tighten the four 3/8" x |
|
|
| |
4" Bolts (8). |
|
|
|
|
| 11 |
|
|
|