10.Attach the Latch Housing (73) to the Left Upright (84) with two #8 x 3/4" Screws (3); start both
Screws and then tighten them. Note: Make sure that the large hole in the Latch Housing is on the indicated side.
Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two collars, place one on each side of the spring.) Next, insert the pin into the Latch Housing (73). Then, tighten the knob onto the pin.
10
| 84 |
73 |
|
Knob |
|
| Spring |
3 |
|
Large | Collar |
Hole | Pin |
11.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see pages 26 and 27).
If you purchase the optional chest pulse sensor (see page 21), follow the steps below to install the receiver included with the chest pulse sensor.
1.Remove the key from the console and unplug the power cord.
Remove the indicated #8 x 3/4" Screw (3) and the Access Door (76) from the back of the Console Base (85).
2.Connect the wire on the receiver (A) to the indi- cated wire extending from the Console Base
(85). Hold the receiver so that the small cylin- der is oriented as shown and is facing the Console Base. Attach the receiver to the plastic posts on the Access Door (76) with the two in- cluded small screws.
3.Make sure that no wires are pinched. Reattach the Access Door (76) with the #8 x 3/4" Screw
(3). Discard the other wires included with the re- ceiver.
85 |
| Wire |
| Small | |
|
| |
|
| Screws |
76 |
|
|
| 3 | A |
| Small | |
|
| |
|
| Cylinder |
10