10.Attach the console assembly with four 3/8" x 1" | 10 |
|
|
|
|
Bolts (4) and four 3/8" Star Washers (8). Start all |
|
|
|
| |
four Bolts before tightening any of them. | 105 |
|
|
| 114 |
Note: The Left Accessory Tray (105) and the the |
|
|
|
| |
Right Accessory Tray (114) are replaceable. If |
| 98 |
|
| |
these parts become dislodged from the Console | 8 |
|
| ||
Base (98), simply press them back in. |
|
|
|
| |
| 4 |
|
|
|
|
|
| 8 |
| Console | |
|
|
| Assembly | ||
11. Identify the Latch Assembly (76). Remove the | 11 |
|
|
|
|
tie from the end of the tube. Make sure that the |
|
|
|
| |
sleeve has been slid over the indicated hole and |
| 108 |
|
| |
that the Latch Knob (108) is locked into the hole. |
|
|
| ||
Pull on the sleeve to make sure that it is | Tube |
| Hole |
| |
locked into place. |
|
| |||
| Sleeve | 76 |
| ||
|
|
|
|
| |
12. Raise the Frame (55) to the position shown. | 12 |
|
|
|
|
Have a second person hold the Frame until |
|
|
|
| |
this step is completed. | 55 |
|
|
|
|
Orient the Latch Assembly (76) so that the large |
|
|
|
|
|
barrel and the Latch Knob (108) are in the posi- | 11 | 3 |
|
|
|
tions shown. Attach the lower end of the Latch |
|
|
| ||
Assembly to the bracket on the Base (85) with a |
|
| 76 |
|
|
3/8" x 1 3/4" Bolt (3) and a 3/8" Nut (11). | 108 |
|
|
| |
Attach the upper end of the Latch Assembly (76) |
| Large |
|
| |
to the bracket on the Frame (55) with a 3/8" x 1 |
|
|
|
| |
3/4" Bolt (3) and a 3/8" Nut (11). Note: It may be |
|
| Barrel |
|
|
necessary to move the Frame back and forth to |
|
| 85 |
|
|
align the Latch Assembly with the bracket. |
|
|
|
| |
Lower the Frame (55) (see HOW TO LOWER | 11 |
|
|
|
|
THE TREADMILL FOR USE on page 21). |
| 3 |
|
| |
|
|
|
|
| |
13.Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see pages 23 and 24). To protect the floor or carpet from damage, place a mat under the treadmill.
10