Power turns, Off during use, Displays, Top

PROBLEM

SOLUTION

2. The power turns

a. Check the circuit breaker (see c. on page 15). If the circuit breaker has tripped,

off during use

wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in.

c. Remove the key from the console and then reinsert it.

d. Make sure that the on/off switch is in the on position (see d. on page 15).

3. The displays of

a. Remove the key from the console and UN-

the console do not

PLUG THE POWER CORD. Next, remove

1/8”

function properly

the screws from the hood and carefully re-

move the hood. Locate the Reed Switch

112

(35) and the Magnet (112) on the left side

of the Pulley (21). Turn the Pulley until the

Top

Magnet is aligned with the Reed Switch.

Make sure that the gap between the

View

Magnet and the Reed Switch is about

1/8”. If necessary, loosen the Screw (8)

and move the Reed Switch slightly. Retighten the Screw. Re-attach the hood, and

run the treadmill for a few minutes to check for a correct speed reading.

4. The walking belt

a. Use only a CUL-listed surge protector, rated at 15 amps, with a 14-gauge cord of

slows when

five feet or less in length.

walked on

b. If the walking belt is overtightened, tread-

mill performance may decrease and the

3–4”

walking belt may be permanently dam-

aged. Remove the key and UNPLUG THE

POWER CORD. Using the included allen

wrench, turn both rear roller adjustment

bolts counterclockwise 1/4 of a turn. When

the walking belt is properly tightened, you

should be able to lift the edges of the

Rear Roller Adjustment Bolts

walking belt 3 to 4 inches off the walking

platform. Be careful to keep the walking

belt centered. Plug in the power cord, insert the key and run the treadmill for a few

minutes. Repeat until the walking belt is properly tightened.

c. If the walking belt still slows when walked on, call our Customer Service

Department toll-free.