While a second person holds the console as° sembly near the Pulse Bar (66), connect the Ground Wire (107) on the Pulse Barto the ground wire from the console assembly,
Connect the wire from the console assembly to the Upright Wire (75), Make sure to connect the connectors properJy (see the inset draw- ing}. The connectors shouJd sJide together easiJy and snap into place, if the connectors do not slide together easily and snap into place,
turn one connector and then try again, IF THE CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAM- AGED WHEN THE POWER mSTURNED ON. Lay the wires inside the bottom of the Pulse Bar (66),
Set the console assembly on the Left and Right Uprights (70, 76), Be careful not to pinch any wires.
Attach the console assembly to the Pulse Bar
(66)with six 3/4" Screws (23), Start all six Screws, before tighten them yet.
10, identify the Left Handrail Cover (68), which has a LEFT sticker on it, Slide the Left Handrail
Cover onto the left Handrail (62) and up against the console assembly, Tighten two Cover Screws (52) into the Left Handrail Cover and the
Left Upright (70); be careful not to overtighten the Cover Screws.
Attach the Right Handrail Cover (74) in the same way,
Ground
Wire
66
23
10
Console
Assembl,
68
62
Console
Assembly
Console Assembly
23 23
52
52