TROUBLESHOOTmNG
Most treadmill problems can be solved by following follow the steps listed, mfyou need further assistance,
the steps below. Find the symptom that applies, and please see the front cover of this manual.
PROBLEM: The power does not turn on
SOLUTmON: a, Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 12). Use only a
b. | After the | power cord has been plugged in, make | sure that the key is inserted into the consols. | |
C, | Check the reset/off circuit breaker located on the | |||
| treadmill | frame | near the power cord. if the switch | |
| protrudes as shown, the circuit breaker has |
| ||
| tripped. To reset the circuit breaker, wait for five |
| ||
| minutes, | and then press the switch back in. | Tripped | |
PROBLEM: The power | turns | off during use |
| |
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above), if the circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. if the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.
c.Remove the key from the console. Reinsert the key into the console.
d.if the treadmill still will not run, see the front cover of this manual.
PROBLEM: The incline of the treadmill does not change correctly
SOLUTmON: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds,
PROBLEM: The disptay of the console does not function property |
| |
SOLUTmON: a, Remove the key from the console and UNPLUG THE | 11 | |
POWER CORD. With the help of a second person, | ||
| ||
carefully tip the Uprights (70, 76) down as shown, |
| |
Remove the three Hood Screws (11) and two 3/4" |
| |
Screws (23), Note: A phillips screwdriver with a shaft |
| |
at bast 5" long is required. | 23 |
22