Washer | Healthrider H450I instruction

AssembJyrequirestwopersons.Setthetreadmillinacbaredareaandremoveallpackingmaterials,Donot disposeof the packingmatedaJsuntil assemMyis completed.

Note:Theundersideofthetreadmillwalkingbeltiscoatedwithhigh@erformancelubricant,Duringshipping,a smallamountof lubricantmaybetransferredtothetopofthewalkingbeltortheshippingcarton,Thisisa normal conditionanddoesnotaffecttreadmillperformance,if thereislubricantontopofthewalkingbelt,simplywipeoff thelubricantwithasoftclothanda mild,non-abrasivecleaner,

Assembly requires the included hex key _ and your own phillips screwdriver

Use the drawings below to identify the hardware used during assembly, Note: if a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tooJs for assemMy.

						< 38
3/4"	Screw	(23)-6	1" Tek Screw (77)-4		1 1/4" Tek Screw (108)-2	Cover Screw (52)-4
0		©			Silver Pulse Bar
3/8"	Star	Pulse Bar Star		Endcap Screw		Console Screw (67)-4
		Washer	(65)-4	(79)-2	Screw (64)-4
Washer	(83)-4

2 3/4" Upright Bolt (85)-2

1, Make sure that the power cord is unplugged.

With the help of a second person, carefully tip the treadmill onto its left side as shown, Partially fold the Frame (26) so that the treadmill is more stable, Do not fully fold the Frame until the treadmill is completely assemMed.

identify the Right Upright (76) which has a RIGHT sticker, Hold the Right Upright near the Base (81), insert the Upright Wire (75) into the Right Upright until the Upright Wire is extending from the upper end of the Right Upright, Note: Make sure that the Upright Wire is extending from the side of the post as shown in the inset drawing, Remove the tie from the Upright Wire,

Thread a 2 3/4" Upright Bolt (85) and a 1" Upright Bolt (84) with 3/8" Star Washers (83) into the Base (81) and the bottom of the Right Upright (76), Do not tighten the Upright Bolts yet,

1" Upright Bolt (84)-2

1 1/4" Bolt (63)-4