Healthrider H500i manual Frame 58 until the treadmill is com Pletely assembled

2. With the help of a second person, carefully tip	2
the treadmill onto its right side. Do not fully fold
the Frame (58) until the treadmill is com-		14		84
pletely assembled.
Insert the other Extension Leg (89) into the base					92
of the Uprights (84). Hold an Extension Leg	44
					8
Nut (67) in the bottom of the Extension Leg, and
thread a 2.25" Extension Leg Bolt (92) with a
Star Washer (8) into the top of the Extension
Leg. Next, thread a 2.5" Extension Leg Bolt (65)
with a Star Washer (8) into the bottom of the		8	67	89
Extension Leg. Firmly tighten the Extension		65
Leg Bolts.					58
Slide the other Front Endcap (44) onto the base
of the Upright (84). Finger tighten a Front
Endcap Screw (14) into the Front Endcap and
the base. Do not fully tighten the Screw yet.
3. Attach two Base Pads (82) to the base of the	3
Uprights (84) with two 1" Tek Screws (83).
	83	82
		84
	83
		82
4. With the help of a second person, carefully raise	4
the Uprights (84) to a vertical position.
Have the second person hold the Handrail (20)	64
near the Uprights (84). Insert the Wire Harness				64
(77) into the hole in the bottom of the Handrail	8				20
and out of the top as shown.				8
Next, set the Handrail (20) on the Uprights (84).					77
Do not let the Wire Harness (77) fall into the
right Upright.
Attach the Handrail (20) with four Handrail Bolts
(64) and four Star Washers (8); start all four		84
Handrail Bolts and then firmly tighten them.
See steps 1 and 2. Fully tighten the two
Front Endcap Screws (14).
	7