Healthrider H500i manual Make sure that no wires are pinched

8.Hand tighten four additional Screws (3) into the Handrail (20) and the console assembly. Then, tighten all nine Screws used in step 7 and this step; do not overtighten the Screws.

9.Attach the Latch Housing (73) to the left Upright (84) with two Screws (3); start both Screws and then tighten them. Note: Make sure that the large hole in the Latch Housing is on the indicated side.

Remove the latch knob from the latch pin. Make sure that the collar and the spring are on the latch pin. (Note: If there are two collars, place one on each side of the spring.) Next, insert the latch pin into the Latch Housing (73). Then, tighten the latch knob onto the latch pin.

8	Console Assembly
	3
3	20
	3
9
	84
	73
Latch Knob
	Spring
	3
	Collar
	Large Hole
	Latch
	Pin

10.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see page 20).

If you purchase the optional chest pulse sensor (see page 16), follow the steps below to install the receiver included with the chest pulse sensor.

1. Remove the key from the console and unplug	85
the power cord.
Remove the Screw (3) and the Access Door
(76) from the back of the Console Base (85).
2. Connect the wire on the receiver (A) to the indi-
cated wire extending from the Console Base
(85). Hold the receiver so the small cylinder
is oriented as shown and is facing the	Small Screws
Console Base. Attach the receiver to the plastic
posts on the Access Door (76) with the two in-	Wire
	A
cluded small screws.
3. Make sure that no wires are pinched.	Small
	Cylinder
Reattach the Access Door (76) with the Screw
	3
(3). Discard the other wires included with the re-	76
ceiver.
	9