12. Apply a generous amount of grease to the | 12 |
| |
axle on the Left Upper Body Leg (24). Then, |
| ||
24 |
| ||
apply grease to a Large Wave Washer (89). |
| 32 | |
|
| ||
Slide an Upper Body Leg Spacer (9) and a | Grease |
| |
|
| ||
Large Wave Washer (89) onto the Left Upper | 9 |
| |
Body Leg (24). Make sure that the flat side of |
| ||
89 |
| ||
the Upper Body Leg Spacer is facing out- | 31 |
| |
ward. | 66 |
| |
At the same time, slide the left Pedal Arm (32) | 86 |
| |
onto the Left Upper Body Leg (24) and insert |
| ||
32 |
| ||
the left Link Arm (30) into the left Link Arm |
| ||
|
| ||
Bracket (107). |
|
| |
Apply a small amount of grease to an M10 x |
|
| |
58mm Patch Bolt (104) and to the left Link Arm |
|
| |
Bracket (107). Attach the Link Arm (30) to the |
| 30 | |
Link Arm Bracket with the Patch Bolt, an M8 x |
|
| |
23mm Washer (31) and an M8 Nylon Locknut |
|
| |
(94). |
|
| |
Then, attach the Pedal Arm (32) to the Left |
|
| |
Upper Body Leg (24) with an M8 x 20mm Patch |
|
| |
Screw (86), an Axle Cover (66), and an M8 x | 104 | Grease | |
23mm Washer (31). | |||
30 | |||
|
| ||
Repeat this step for the right Pedal Arm (32) |
|
| |
and the right Link Arm (30). | 31 | 107 | |
| |||
See step 4. Tighten the M8 x 20mm Button | 94 |
| |
Screws (85). |
|
| |
13. Tighten an Adjustment Knob (52) onto an | 13 |
| |
Adjustment Pin (101). |
| ||
|
| ||
Repeat this step for the other Adjustment |
|
| |
Knob (not shown) and the other Adjustment |
|
| |
Pin (not shown). |
|
| |
Note: See HOW TO ADJUST THE STRIDE OF |
|
| |
THE ELLIPTICAL EXERCISER on page 13 and |
|
| |
make sure that the right and left sides of the ellip- |
|
| |
tical exerciser are adjusted to the same stride |
|
| |
length. | 52 |
| |
| 101 |
|
14.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.
11