NordicTrack NTE13920 Bolt Set 65. Make sure that the Bolt Set, Pedal, As shown, Do not pinch

7. Identify the Left Pedal (10), which is widest at the rear	7
and has an opening on the left side. Attach the Left			118
Pedal to the Left Pedal Leg (4) with two M8 x 58mm
Button Screws (83).
Attach the Right Pedal (11) to the Right Pedal Leg (5)
in the same way.			5
Attach two Pedal Wheels (28), an M10 Washer (126),				11
and the Left Upper Body Leg (31) to the Wheel Frame
(30) on the Left Pedal Leg (4) with an M10 x 78mm		31	65	Wide
Bolt Set (65). Make sure that the Bolt Set, Pedal				End
Wheels, Washer, and Upper Body Leg are oriented		126
as shown.		30
Attach the other two Pedal Wheels, the Right Upper	28		28
Body Leg, and an M10 Washer (not shown) to the				10
Wheel Frame (not shown) on the Right Pedal Leg (5)		65
in the same way.			4
			83
8. Have another person hold the Console (17) near the	8
Upright (2).
			17
	Do not pinch
Connect the Upper Wire Harness (115) to the wire har-		the wires
ness on the Console (17). Connect the Pulse	during this step.
Extension Wire (114) to the pulse wire on the Console.
Next, locate the two ground wires that are attached			114
with a screw to the Upright (2). Connect the ground
		98
wires to the two smallest wires on the Console.
Carefully insert all excess wiring up into the Console				115
(17) and down into the Upright (2). Attach the Console
				Ground
to the Upright with four M4 x 16mm Screws (98).		98
				Wires
(Note: The Screws may be shipped in the console
box.) Be careful to avoid pinching the wires.
				2
9. Plug the Power Cord (116) into the Power Socket	9
(117) at the rear of the elliptical exerciser.
			117	116

10.Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath the elliptical exerciser to protect the floor from damage. Note: Some extra hardware may be left over.

8