Assembly

Assembly requires two people. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the two

included allen wrenches, assembly requires a phillips screwdriver			, an adjustable
wrench	, a rubber mallet	, and pliers	.

As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 22. The second number refers to the quantity used in assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.

M8 x 19mm	M10 x 25mm	M8 Split	M10 Split	M8 Washer	M10 Washer
Screw (30)–4	Screw (109)–3	Washer (58)–4	Washer (22)–11	(33)–4	(63)–2
M10 x 43mm Screw (65)–4		M10 x 56mm Screw (60)–4		M10 x 36mm Carriage Bolt (61)–2
1. Identify the Rear Stabilizer (59), which has Leveling			1		60
			1		60
Feet (14) threaded into it. Attach the Rear Stabilizer to				60	22
the Frame with the four M10 x 56mm Screws (60) and				60
the Frame with the four M10 x 56mm Screws (60) and
four M10 Split Washers (22).
					1
				22	59
				22
					14
2. Attach the Front Stabilizer (90) to the Frame (1) with			2		65
			2		65
the four M10 x 43mm Screws (65) and four M10 Split
Washers (22). Make sure that the Front Stabilizer is					22
turned so the Wheels (45) are not touching the
floor.				65
				65
				22	1
			45
					90
			5