ParaBody cm3 manual Pulley Plates

Page 13

 

35

38

4-1/2” PULLEY

 

 

3/8 X 3-3/4”

57

51

 

 

 

 

 

 

63

 

 

15

 

FIGURE 13

 

 

 

STEP 13:

Assemble one 4-1/2” PULLEY (38) to the BOOM PLATES (14 & 15) using one 3/8 X 3-3/4” BOLT (57), one 3/8 X 1” SPACERS (51), one 4-1/2” CABLE GUARD (35) and one 3/8” LOCK NUT (63). See FIGURE 13.

IMPORTANT! Uncoil and straighten all CABLES in order to remove all twist prior to installation

STEP 14:

Assemble the WEIGHT STACK PIN (27) to the WEIGHT STACK SHAFT (26) as shown in FIGURE 14.

Screw the long threaded end of the WEIGHT STACK CABLE (29) into the end of the WEIGHT PLATE SHAFT (26) .See FIGURE 14.

Route the WEIGHT STACK CABLE (29) around the pulleys in the BOOM PLATES (14 & 15) as shown in FIGURE 14. (NOTE: Make sure the cable runs in the grooves of the pulleys.)

Assemble two PULLEY PLATES (10) around one 3-1/2” PULLEY (37) using one 3/8 X 1-3/4” BOLT (53) and one 3/8” LOCK NUT (63) as shown in FIGURE 14. (Note: Loop the CABLE around the PULLEY prior to assembling the

PULLEY PLATES.)

FIGURE 14

 

3/8 X 1-3/4” 53

 

29

 

37

63

10

 

26

 

27

 

13

 

Image 13
Contents CM3 GYM System Important Safety Information Important Notes ’ 2’ 3’ 4’ 5’ 6’ 7’ 8’ 9’ KEY Description QTY Parts ListStep Page Option only CM3 ShroudTighten 71 3/8 X 3/4 Loctite Step LOC-TITE Pulley Plates Short Cable X 2-3/4 X 1-3/4 Step X 4-1/4 X 3-3/4 Base Plates PlatesARM Cable Support Right ARMTighten Step Step Adjustment Maintenance Limited Warranty Life Fitness Consumer Division