ParaBody 883 manual Optional

Page 22

FIGURE 11

23

3

6

20

12

OPTIONAL 50

LB. ADD-ON KIT

11

19

5

880 SHROUD

OPTION ONLY!

1

STEP 11:

Insert two GUIDE RODS (3) into the STACK BASE (1) as shown on FIGURE 11. (NOTE: If the 880 SHROUD OPTION was purchased, place the GUIDE RODS (3) through the BOTTOM SHROUD BRACKET (found in SHROUD OPTION box) and into the STACK BASE (1) as shown in FIGURE 11.

(NOTE: Lubricate GUIDE RODS (3) with silicon or teflon spray available at most hardware stores.)

Slide two WEIGHT STACK SPACERS (5), two 3/4” FLAT WASHERS (19), and two WEIGHT STACK CUSHIONS (11) down over the GUIDE RODS (3).

Using EXTREME CARE slide all fifteen WEIGHT PLATES (20) (NOTE: If 50-LB. ADD-ON KIT was purchased, slide twenty

WEIGHT PLATES and discard two WEIGHT STACK SPACERS (5), two 3/4” FLAT WASHERS (19) use the 50 LB. ADD- ON HEAD PLATE and refer to the 50 LB. ADD-ON Kit instructions) down over the GUIDE RODS (3) on to the WEIGHT STACK CUSHIONS (11). Make sure that the WEIGHT PLATES (20) are all facing as shown.

Slide the head plate assembly down over the GUIDE RODS (3) onto the weight stack.

Slide two SHAFT COLLARS (23) over the GUIDE RODS (3) as shown in FIGURE 11.

Apply WEIGHT STACK LABELS (12) to WEIGHT PLATES (20) and HEAD PLATE (6) as shown in FIGURE 11. Begin with

number one at the HEAD PLATE (6) with larger numbers in consecutive order towards bottom of weight stack.

22

Image 22
Contents Second Stack Option For 880 GYM System Important Safety Information Important Notes Parts List Step Rear Upright Step Optional Boom Plate Frame 3NYLON Spacer Rear Upright Nylon Pulley Boom Bracket Weight Stack Cable Step Step Boom Pulley Plates Adjustment Step Short LEG Press Cable Short LEG Press Boom Bracket Short LEG Press Cable Frame Pulley Bracket PEC Station PAD Frame Step Optional Boom Plate Frame 2NYLON Boom Bracket Spacer Rear Upright Pulley Make sure the cable runs in the grooves of the pulleys LAT Cable Step Boom Base Cable Routing Diagram Adjustment