ParaBody 425103 manual Justment Tube 22 to rotate freely

	62
	96 3/8 X 1”
	BUTTON HD
	CAP SCREW
	3
13	95 LOW
	HEIGHT
	NUT
	78
	22
	62
	1/2 X 3-1/2” 90
FIGURE 20

STEP 20

•Attach eight PARAGLIDE STRIPS (62) INSIDE the end of the RECEIVING TUBE (13) and four PARAGLIDE STRIPS (62) to the OUTSIDE of the PRESS ADJUSTMENT TUBE (22) using the following steps:

•Thoroughly clean all sufaces where PARAGLIDE STRIPS (62) are to be attached.

•Remove the PARAGLIDE STRIPS (62) from the paper backing and firmly apply them to surfaces. (NOTE: Orientate the strips so they will slide by each other.)

•CAREFULLY slide the PRESS ADJUSTMENT TUBE (22) into the RECEIVING TUBE (13). (NOTE: Make sure the spring pin barrel on the RECEIVING TUBE (13) is on the same side as the holes in the PRESS ADJUSTMENT TUBE (22).)

•Thread one 3/8 X 1” BUTTON HEAD CAP SCREW (96) through the slot in the RECEIVING TUBE (13) and into the ADJUSTMENT TUBE (22)

•Insert two 1/2” FLANGE BEARINGS (78) into the COUNTER LEVER (3) as shown in FIGURE 20.

•Assemble the PRESS ADJUSTMENT TUBE (22) to the COUNTER LEVER (3) using one 1/2 X 3-1/2” BOLT (90) and one 1/2” LOW HEIGHT LOCK NUT (95). (NOTE: Tighten the connection enough to remove play, yet allowing the PRESS AD-

JUSTMENT TUBE (22) to rotate freely.)

19