ParaBody 425103 manual PEC Cable

	42
	92
	98
	91
	84 3/8 X 2”
FIGURE 37	29

STEP 37

•Assemble one 3-1/2” PULLEY (42) around the PEC DEC CABLE (98) and to the PULLEY BRACKET (29) using one 3/8 X 2” BOLT (84), two 3/8” WASHERS (91) and one 3/8” LOCKNUT (92) as shown in FIGURE 37.

26
98	24
98
PEC
CABLE
	FIGURE 38
STEP 38

•Slide the ends of the PEC DEC CABLE (98) into the bushings on the PEC CAMS (24) as shown on FIGURE 38.

•Lay the PEC DEC CABLE (98) over the pulleys and under the cable retaining clips in the CENTER PULLEY BRACKET (26) as shown in FIGURE 38. (NOTE: Securely tighten the pulley connections in the CENTER PULLEY BRACKET (26). The cable retaining clips should be at approximately a 45° angle.)

	1/2		1/2		1/2		1/2		1/2		1/2
0		1		2		3		4		5	6

33