ParaBody 425103 manual Detail

FIGURE 39	92	25
		103 AB CABLE
	42		91
SEE DETAIL 39		49
		3/8 X 2-3/4”	85
			DETAIL 39

STEP 39

•Securely assemble the ball end of the AB CABLE (103) and one 3-1/2” PULLEY (42) to the FRONT UPRIGHT (25) using two 3/ 8 X 2-3/4” BOLTS (85), two 3/8” FLANGE SPACERS (49), two 3/8” WASHERS (91), and two 3/8” LOCKNUTS (92). (NOTE: The

AB CABLE (103) should be routed underneath the retaining bolt as shown in DETAIL 39.)

FIGURE 40	STEP 40
	• Run the AB CABLE (103) through the
	floating pulley assembly, then screw the
29	threaded end of AB CABLE (103)
103	approximately 3/4” into the end of the
	PULLEY BRACKET (29) and tighten jam
	nut securely as shown in FIGURE 40.
FLOATING	IMPORTANT! Make sure the cables are
PULLEY
	running in the grooves of all pulleys.
34