102

FIGURE 32

STEP 32

•To assemble the D-RING CABLE (102) follow the cable routing as shown and use the following steps:

•Screw one of the threaded ends of the D-RING CABLE (102) approximately 1” into the end of the SELECTOR SHAFT (73) of the HEAD PLATE (72) as shown in FIGURE 32.

•Route the CABLE (102) up and over the two PULLEYS in the TOP BOOM (17) above the WEIGHT STACK. (Remove pulleys for ease of installation.)

•Screw the other threaded end of the D-RING CABLE (102) approximately 1” into the end of the shaft on the D-RING (7) as shown in FIGURE 32.

•SECURELY tighten two pulley connections from the previous step.

	1/2		1/2		1/2		1/2		1/2			1/2
0		1		2		3		4		5		6