Detail | ParaBody 425103 instruction

	23
38
12
91
3/8 X 2-3/4” 85
		91 63
	51	108
	51	64 3/8 X 2-1/2” SOCKET
		HEAD CAP SCREW
	3/8” HEX NUT 108	DETAIL 30
	63	DETAIL 30
FIGURE 30	63
FIGURE 30	64 3/8 X 2-1/2” SOCKET HEAD CAP SCREW

STEP 30

•SECURELY assemble one 3/8” SPRING PIN (51) to the spring pin housing of the PRESS BACK SUPPORT (23). (NOTE: Tighten the nut of the SPRING PIN ASSEMBLY SECURELY.)

•SECURELY assemble two 3” WHEELS (63) using two BLACK 3/8 X 2-1/2” SOCKET HEAD CAP SCREWS (64) and two 3/8” HEX NUTS (108) as shown in DETAIL 30.

•SECURELY assemble two wheel assemblies to the PRESS BACK SUPPORT (23) as shown in FIGURE 30.

•SECURELY assemble the SEAT PAD (38) to the PRESS SEAT ADJUST (12) using two 3/8 X 2-3/4” BOLTS (85) and two 3/8” WASHERS (91). See FIGURE 30.

•Pull back the 3/8” SPRING PIN (51) on the PRESS BACK SUPPORT (23) and slide the PRESS SEAT ADJUST (12) into the receiving well. Engage the 3/8” SPRING PIN (51) into one of the adjustment holes.