Reebok Fitness RBEL9906.3 manual Assembly, Screw M10 x 93mm Button Screw

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included hex keys and your own Phillips screwdriver and rubber

mallet .

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe- ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the hardware kit, check to see if it has been preassembled.

M6 Split Washer		M8 Split	M8.5 x 16mm x	M10 x 25mm	M10 Curved		Link Arm
			1.5mm Washer
(102)–8	Washer (101)–4		(103)–6	Washer (87)–2	Washer (99)–4		Spacer (74)–4
		M4 x 16mm	M6 x 35mm			M6 x 62mm
Wave Washer	Screw (116)–16		Screw (109)–4			Screw (108)–4
(100)–2
M8 x 15mm Button		M8 x 20mm Button		M8 x 25mm Button		M10 x 20mm Button
Screw (106)–10		Screw (107)–4		Screw (110)–2			Screw (111)–2
			M10 x 93mm Button Screw (82)–4

1. If there is a shipping bracket attached to the	1
rear of the Folding Frame (not shown), remove
the screw and the shipping bracket from the	82	99
Folding Frame. Discard the screw and the ship-			1
ping bracket.
See HOW TO FOLD AND UNFOLD THE	99
ELLIPTICAL EXERCISER on page 11 and
unfold the elliptical exerciser.
While another person lifts the front of the		4
Frame (1), attach the Front Stabilizer (4) to the
Frame with two M10 x 93mm Button Screws
(82) and two M10 Curved Washers (99).
	5