HOW to USE a Custom Program

1.Turn on the console. See step 1 on page 14.

2.Select a custom program.

To select a custom program, press the Custom Programs button repeatedly until the words CUS- TOM 1 or CUSTOM 2 appear in the display.

When you select a custom program, the name of the program, the program time, and the maximum pace and resistance level will appear in the display for a few seconds. A profile of the resistance levels of the program will then appear in the display.

Profile

3.Begin pedaling to start the program.

Each custom program is divided into 30 one- minute segments. One resistance level and one target pace setting are programmed for each seg- ment. Note: The same resistance level and/or tar- get pace setting may be programmed for two or more consecutive segments.

During the program, the program profile will show your progress. The flashing segment of the profile represents the current segment of the program.

The height of the flashing segment indicates the resistance level for the current segment. At the end of each segment of the program, a series of tones will sound and the next segment of the pro- file will begin to flash. If a different resistance level is programmed for the next segment, the resis- tance level will appear in the display for a few sec- onds to alert you. The resistance of the pedals will then change.

As you exercise, you will be prompted to

keep your pedaling

pace near the target pace setting for the cur-

rent segment. When an

upward-pointing arrow or the prompt SPEED UP appears next to the pace information in the display (see step 4 on page 17), increase your pace. When a downward-pointing arrow or the prompt SLOW DOWN appears, decrease your pace. When no arrow or prompt appears, maintain your current pace. Important: The target pace set- tings are intended only to provide motivation. Make sure to pedal at a pace that is comfort- able for you.

If the resistance level for the current segment is too high or too low, you can manually override the setting by pressing the OneTouch Resistance but- tons. However, when the current segment ends, the pedals will automatically adjust to the resis- tance level for the next segment.

If you stop pedaling for several seconds, a series of tones will sound and the program will pause. To restart the program, simply resume pedaling. The program will continue until the last segment of the profile flashes and the last segment of the pro- gram ends.

4.Change the program if desired.

If desired, you can change the program while using it. To change the resistance level for the current segment, simply press the OneTouch Resistance buttons. At the end of the current seg- ment, the new resistance level will be stored in memory. To change the target pace for the cur- rent segment, simply change your pedaling pace. At the end of the current segment, your pace will be stored in memory. You can continue exercising and changing the program for up to thirty minutes.