Life Fitness SM42 manual Installing the Cables, Removing the pulley bolts

Page 12

SM42 Unpacking & Assembly Instructions

INSTALLING THE CABLES

The SM42 uses four cables. There are two different types of cable used on the SM42. They are:

1.Adjustable crossover cables (ball end cables) (2).

2.Lat pulldown and tricep cables (2).

The lat and tricep cables can be identified by their short length and the adjustable crossover cables can be identified by the ball on the end of the cable. The routings for these cables are shown in the figures below.

NOTE: YOU MUST REMOVE ALL PULLEYS TO ROUTE THE CABLES. USE A 9/16” COMBINATION WRENCH AND SOCKET TO DO THIS (SEE FIGURE 16). YOU MAY WISH TO REMOVE THE SHOULDER BOLTS (FIGURE 16 RIGHT SIDE) BY USING A 3/8” COMBINATION WRENCH AND A 1/8” HEX KEY WRENCH. WHEN YOU HAVE ROUTED THE CABLES, REPLACE ALL PULLEYS AND PLACE END CAPS ON NUT AND BOLT ENDS. YOU MAY NEED TO PRY THE PULLEY HOUSINGS OPEN TO REPLACE THE PULLEYS.

Figure 16. Removing the pulley bolts.

12

Image 12
Contents M051-K50-A142 Materials and Tools Required for Assembly Assembly TimeParts box contents UnpackingAssembly SM42 main componentsSet the weight stack cells Configuration for 2-3/4 and 3 bolts Configuration for 6 bolts Putting on the weight stacks SM42 Unpacking & Assembly Instructions X 3 Bolt the benches to the frame Installing the Cables Removing the pulley boltsAdjustable Crossover Cable Routing LAT Pulldown Cable Routing Tricep Pushdown Cable Routing Hardware . Assembly Parts HardwareHardware . Rubber cap Hardware . Cable jam nut Hardware . CablesHardware . Top assemblies Hardware . Weight stack rubber bumpers Hardware . Floating pulleysMain components Cables, caps & nutsBolt hardware Pulleys and bumpersInstalled Hardware installedPulley hardware Floating pulley