SM42 Unpacking & Assembly Instructions
The parts shown in Hardware Figure 1 are used to assemble the SM42. They are:
A.7/16” x 6” hex head bolt (used to bolt the tricep top beam, adjustable crossover top beam, lat top beam, and connecting beam to the tops of the cells)
B.7/16” flat washer
C.7/16” cap washer (used on the head end of the 6” bolt so end cap will fit on the nut)
D.7/16” hex head nut
E.3/8” x 3” hex head bolt (used to bolt the cross beam to the cross members, the adjustable pulley tops to the top beams, and the bottom bolts on the lat bench)
F.3/8” x
G.End caps (bolt covers)
H.3/8” flat washer
J.3/8” end cap washers (end caps snap onto them)
K.3/8” Nyloc (locknut)
The black rubber caps shown in Hardware Figure 2 are used to cap the ends of the cables that are threaded to the adjustable pulleys.
Hardware Figure 2. Rubber cap.
L. Rubber cap
17