Life Fitness 660 manual 102

Page 34

17

102

7

72

FIGURE 35

STEP 35

•To assemble the D-RING CABLE (102) follow the cable routing as shown and use the following steps:

•Screw one of the threaded ends of the D-RING CABLE (102) approximately 1” into the end of the shaft on the HEAD PLATE (72) as shown in FIGURE 35.

•Route the CABLE (102) up and over the two PULLEYS in the TOP BOOM (17) above the WEIGHT STACK. (Remove pulleys for ease of installation.)

•Screw the other threaded end of the D-RING CABLE (102) approximately 1” into the end of the shaft on the D-RING (7) as shown in FIGURE 35.

•SECURELY tighten two pulley connections from the previous step.

 

1/2

 

1/2

 

1/2

 

1/2

 

1/2

 

 

1/2

0

1

2

3

4

5

6

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents GYM System Important Safety Information Important Notes Square = 1’ X 1’ Parts List Step 87 1/2 X Hexnut Step 84 3/8 X Step 88 1/2 X X 3 108108 3/8 HEX NUT Step 104 105 Step Step Step Step LOW Height NUT PUSH/PULL Underside Justment Tube 22 to rotate freely LOW Height NUT Detail Button Cable has been routed 90 1/2 X 3-1/2 Post Detail Support Tube to rotate freely Hexnut Page 102 Cable Installation 100 Cable LAT PEC Cable See Detail 83 3/8 101 Legext Cable LAT Cable Press Step Legext Press Cable Base LEG Cable Elastic Cord LAT Cable 105 96 3/8 X 1 Button Step Maintenance Limited Warranty International Offices
Top Page Image Contents