Push/Pull | Life Fitness 660 instruction

	27
	58
60	59
57
56	47
56
	PUSH/PULL
	CABLE
FIGURE 20

STEP 20

•Insert the PUSH/PULL CABLE through the bottom of the PRESS ARM (27) up to the CONTROL LEVER (60) and hold in place with one E-RING (56) as shown in FIGURE 20.

•SECURELY assemble the PUSH/PULL CABLE to the CONTROL LEVER (60) using one 3/8” JOINT CONNECTOR CAP (57), one #10 FLAT WASHERS (59), and one 8-32 X 3/16 IN. SCREWS (58) as shown in FIGURE 20.

•Slide one 4” VINYL SLEEVE (47) over the CONTROL LEVER (60). Then SECURELY assemble the CONTROL LEVER (60) to the TAB on the PRESS ARM (27) using one 3/8” JOINT CONNECTOR CAP (57), one #10 FLAT WASHERS (59), and one 8-32 X 3/16 IN. SCREWS (58) as shown in FIGURE 20.

	1/2		1/2		1/2		1/2		1/2			1/2
0		1		2		3		4		5		6