Securing the SPA Cover, Latch Buckle Key, Jet

water. Refer to the instructions on the test strip pack- aging to see how to use the test strips.

If the level is too low, add half of one of the “QUICK pHix It UP” packets to the water. Let the water circu-

SECURING THE SPA COVER

The spa cover can be secured by snapping the latch- es on the spa cover into the buckles on the side panels.

late through the spa jet unit for five minutes. Test the pH level again. Repeat until the pH level is correct.

If the level is too high, add half of one of the “QUICK pHix It DOWN” packets to the water. Let the water cir- culate through the spa jet unit for five minutes. Test

the pH level again. Repeat until the pH level is correct.

Replace the spa cover and allow the water to contin- ue to heat.

The buckles can be locked by inserting the key and turning it clockwise a quarter turn. To unlock the buckles, insert the key and turn it counter- clockwise a quarter turn.

Latch

Buckle

Key

See WATER CHEMISTRY on page 13 for information concerning proper water maintenance.

Always keep the buckles locked when the spa is not in use. Keep the keys in a safe place, out of the reach of children.

DIAGRAM OF THE CONSOLE

USING THE CONSOLE

Refer to the console diagram above. The function of each console control is explained below:

Primer: This opening allows you to prime the spa jet unit before operation (see PRIMING THE SPA JET UNIT on page 10).

Diverter: Controls the flow of water through the hydro-therapy jets and the whirlpool jet. The direction of the flow can be adjusted by turning the diverter control. When the control is set to “front,” the flow will be through the hydro-therapy jets; when it is set to “side,” the flow will be through the whirlpool jet; when it is set to “all,” the flow will be evenly distributed through both the hydro-therapy jets and the whirlpool

jet.

Thermostat: Controls the temperature of the water. The water heats at about 1.7°F an hour with the cover on. The thermostat can be set to heat the water from 70°F to 104°F. Use a medical or other accurate ther- mometer to check the temperature of the water.

On/Off: Turns the spa jet unit on and off. When you first press the on/off button, the spa jet unit will run at low speed, providing gentle hydrotherapy. Press the

button again and the spa jet unit will run at high speed, providing more intense hydrotherapy. Press

the button a third time and the spa jet unit will shut off.

The spa jet unit also features an automatic mode, which heats and filters the water when the spa is left unattended. When the spa jet unit is first plugged in, or if the buttons on the console have not been used

for longer than twenty minutes, the automatic mode will begin filtering or heating the water, as needed.

Note: to keep the filter and heat cycles from run- ning, the power cord must be unplugged.

Air Control: Determines the amount of air that is in the spa jet system during operation. If the control is turned to the left, the amount of air flowing through the jets will increase. If the control is turned to the right, the amount will decrease.