Image 831.100430 user manual SPA JET Unit Operation, Draining the Renew, Draining the Pump

SPA JET UNIT OPERATION

The spa jet unit features five hydro-therapy jets, a whirlpool jet, a suction vent, and a filter housing.

The five hydro-therapy jets (A), located on the front of the spa jet unit, focus the water massage on your

neck and back.

	B
	A
D	C

The	whirlpool jet (B), located on the left side of the
spa jet unit, directs the flow of the water to create a
whirlpool action in the RENEW 900.
The	suction vent	(C),
located on the right
side of the spa jet
unit,	pulls the water
into the spa unit, in
order	to operate the
system. The suction
cover should always
be in place over the
suction vent.		Never
operate the RENEW		C
900 without the suc-
tion cover in place.
The	filter (D), is locat-		Filter Cover
ed on the left side		of
			Screws
the spa jet unit,
behind	the filter cover.
The filter can be			Filter Cover
removed for cleaning
and replacement by			D
removing the Filter
Cover and the two

filter cover screws and then pulling the filter from the spa jet unit.

The spa jet unit features an automatic filter cycle and freeze protection. If the spa jet unit has not been operated for three hours, the pump will begin circulat-

ing the water for twenty minutes to filter any impuri- ties. Also, if the water temperature falls below 40°F, the pump will begin circulating and heating the water to prevent the water from freezing.

DRAINING THE RENEW 900

To drain the RENEW 900, you must use a garden hose to siphon the water. Place one end of the hose in the RENEW 900 and hold it in front of a hydro- therapy jet until there is a flow of water coming out of

the hose.	Turn off the spa unit and unplug the
power cord. The unit will be damaged if it is run
without water circulating.		Be sure the end of the

hose in the RENEW 900 is on the floor of the spa.

DRAINING THE PUMP

After the RENEW 900 is drained (see DRAINING
THE RENEW 900 above), the pump in the spa jet unit
should also be drained if the RENEW 900 will be
stored for more than thirty days, or if it may be
exposed to freezing temperatures.
To drain the pump,
remove the spa jet
unit from the side pan-
			Pump
els. Be careful not to
tear the inflatable
spa liner.	Locate the
pump inside the spa
jet unit. Remove the
drain plug from the				Drain Plug
pump. Tip the spa jet
unit slightly, until all the water has drained from the
pump. Replace the drain		plug.

12