Image 831.100430 Symptom the SPA JET Unit Continues, Power cord must be unplugged, Care on

Page 15

b. Check the chemical balance of the water. If the pH is incorrect, the sanitizing agents will not function properly.

10. SYMPTOM: THE SPA JET UNIT CONTINUES

TO RUN AFTER IT HAS BEEN SHUT OFF
a. When you press the on/off button once, the spa
jet unit will run at low speed, heating the water.
Press the button again and the spa jet unit will
run at high speed, filtering the water. Press the
button a third time and the spa jet unit will shut
off. The spa jet unit also features an automatic
mode, which heats and filters the water when
the spa is left unattended. When the spa jet
unit is first plugged in, or if the buttons on the
console have not been used for longer than
twenty minutes, the automatic mode will begin
filtering or heating the water, as needed. To
keep the filter and heat cycles from running,
the power cord must be unplugged.	Special
Note: If the unit is to be kept outdoors in
cold weather, you must allow the spa to
maintain a safe temperature by running in
automatic mode. Allowing the spa jet unit to
freeze will damage the unit. If you do not
want to use the spa during the winter, store
it in a warm, dry location (see WINTER USE
AND CARE on page 13).

11. SYMPTOM: THE WATER LEVEL DROPS

a. Some water loss due to evaporation is normal.

If rapid water loss occurs, or if you notice wet- ness on the floor around the RENEW 900, then

the liner may have a leak. Locate the leak, and patch it using a pool patch kit that you can pur- chase at any pool and spa supply store.

b. A clamp or seal inside the spa jet may be loose. Check the floor around the spa jet unit for excess water, and watch the spa jet unit while it is operating to see if water drips from the spa jet unit housing. If you can identify the location of the leak inside the spa jet unit, tight- en the clamp or replace the damaged seal.

12.SYMPTOM: THE INFLATABLE SPA LINER LOSES AIR

a.Over time, some air loss is normal. If rapid air loss occurs, then the liner may have an air leak. Locate the leak, and patch it using a pool patch kit that you can purchase at any pool and spa supply store.

15

Image 15

Contents Sears CANADA, INC., TORONTO, Ontario M5B 2B8 QUESTIONS?Model No Serial No Customer HOT LineTable of Contents Important Safety Instructions Use the Renew 900 only as described in this manualWater pump in the spa jet unit must be Keep pets away from the Renew 900 at all times Hol or drugs can cause unconsciousnessContact a physician Image Before YOU Begin Do not use an extension cord with the Renew If you set up the Renew 900 insideIf you set up the Renew 900 outside Choosing a Location for the RenewBuckle Slot AssemblyBefore beginning assembly, carefully read Following information and instructionsLatches and Buckles BucklePlugging in the Renew Using the RenewTesting and Treating the Water Priming the SPA JET UnitJet Diagram of the Console Using the ConsoleSecuring the SPA Cover Latch Buckle KeySPA JET Unit Operation Draining the RenewDraining the Pump Maintenance Symptom the Water Pulsates or There is Minimum Water Flow Symptom the SPA will not OperateSymptom the Pump Hums Symptom the Water does not HeatCare on Symptom the SPA JET Unit ContinuesPower cord must be unplugged Symptom the Water Level DropsModel Number of the product Name of the product Image Ordering Replacement PartsDe l’Industrie St-Jérôme, Québec Canada, J7Y 4B8 Customer RecordModel No Serial No DateProduct Warranty Registration Limited Five Year Massage SPA WarrantyReferences Du Modèle De Série’Achat Formulaire DE Garantie DU Produit Garantie Limitée DE Cinq ANSKey No. Qty Description Part LIST-Model NoR0499A 100430