Evo Fitness 50551 owner manual Assembly

Page 10

instructions

ASSEMBLY

assembly

 

Step 3:

Attach the Squat Support (5) to the Side Base (2) and Squat Base (4) using two 1/2" Washers (89) and two 1/2" Nylon Nuts (93) for each.

Cap the Pec Dec Base (6) with one 2" Sq End Plug (50) and one 2" Sq End Cap (48). Attach the Pec Dec Base (6) to the Base Frame (1) using two 1/2" x 3-1/8" Hex Head Bolts (71), six 1/2" Washers (89) and four 1/2" Nylon Nuts (93). Align the mounting holes in the link plate (welded on Base Frame (1)) with the holes in the Pec Dec Base (6) then attach with two 1/2" x 3-1/8" Hex Head Bolts (71), four 1/2" Washers (89) and two 1/2" Nylon Nuts (93).

Attach the Seat / Back Pad (31) to the Pec Dec Base (6) using two 3/8" x 2- 3/4" Hex Head Bolts (79) and two 3/8" Washers (90).

LINK PLATE

-10-

Page 9 Page 11
Image 10
Page 9 Page 11
Contents EVO Sedona Home Gym Preassembly Before BeginningParts list Majority of the Listed Hardware is Already in PlacePlace Majority of the Listed Hardware is AlreadyADJ Cable Small Pulley Parts diagram By the FactoryAssembly InstructionsAssembly instructions StepAssembly Assembly instructions Detail TOP View Assembly instructions Bracket Assembly instructions Firmly tighten all fasteners at this time TOP Cable TOP Cable PathFIG-C2,C6 Connect Cable Path FIG-C1,C7FIG-C3 FIG-C4,C5PEC DEC Cable Path PEC DEC CableFIG-P1,P8 FIG-P3 FIG-P4 FIG-P5,P6 Lower Cable Routing the Lower CableAssembly instructions Assembly instructions Page Warranty WarrantyImportant steps Important StepsYour Target Zone Target heart rateExercising Muscle chart Muscle ChartCool Down Stretching routineWarm UP Shoulder Lift Page
Top Page Image Contents