Evo Fitness 50551 owner manual Assembly instructions

Page 11

ASSEMBLY

Step 4:

Cap the Squat Lever (8) with one 2" End Plug (50). Cap the Squat Arm (9) with two 2" Round End Plugs (51).

Insert the Squat Axle (24) into the hole in the Upright (3) and through the sleeves in the Squat Lever (8), Squat Arm (9) and Squat Support (5). Attach using one 1/2" x 1" Hex Head Bolt (78) and one 1/2" x

1-1/2" Washer (87). Insert one Cap For Nut (55) over the head of the 1/2" x 1" Hex Head Bolt (78).

Secure the Squat Axle (24) with one 5/16" x 5/8" Set Screw (86). Cap the Squat Support (5) with one 2" x 3" Rect End Plug (52).

assembly instructions

-11-

Image 11

Contents EVO Sedona Home Gym Before Beginning PreassemblyMajority of the Listed Hardware is Already in Place Parts listMajority of the Listed Hardware is Already PlaceADJ Cable Small Pulley By the Factory Parts diagramInstructions AssemblyStep Assembly instructionsAssembly Assembly instructions Detail TOP View Assembly instructions Bracket Assembly instructions Firmly tighten all fasteners at this time TOP Cable Path TOP CableFIG-C4,C5 Connect Cable Path FIG-C1,C7FIG-C3 FIG-C2,C6FIG-P1,P8 FIG-P3 FIG-P4 FIG-P5,P6 PEC DEC CablePEC DEC Cable Path Routing the Lower Cable Lower CableAssembly instructions Assembly instructions Page Warranty WarrantyImportant Steps Important stepsExercising Target heart rateYour Target Zone Muscle Chart Muscle chartWarm UP Stretching routineCool Down Shoulder Lift Page