Evo Fitness 50551 owner manual Assembly instructions, Step

Page 9

ASSEMBLY

Step 2:

Cap the Squat Base (4) with one 2" Sq

End Plug (50). Attach the Squat Base

(4)to the Base Frame (1) using three 3/8" x 3/4" Hex Head Bolts (82) and three 3/8" Washers (90). Align the mounting holes in the link plate (welded on the Squat Base (4)) with the holes in the Side Base (2) then attach using two 1/2" x 3-1/8" Hex Head Bolts (71), four 1/2" Washers (89) and two 1/2" Nylon Nuts (93).

Attach the Foot Plate (21) to the Squat Base (4) using two 3/8" x 3" Hex Head Bolts (74), four 3/8" Washers (90) and two 3/8" Nylon Nuts (94).

LINK PLATE

assembly instructions

-9-

Image 9

Contents EVO Sedona Home Gym Before Beginning PreassemblyMajority of the Listed Hardware is Already in Place Parts listMajority of the Listed Hardware is Already PlaceADJ Cable Small Pulley By the Factory Parts diagramInstructions AssemblyStep Assembly instructionsAssembly Assembly instructions Detail TOP View Assembly instructions Bracket Assembly instructions Firmly tighten all fasteners at this time TOP Cable Path TOP CableFIG-C3 Connect Cable Path FIG-C1,C7FIG-C2,C6 FIG-C4,C5PEC DEC Cable PEC DEC Cable PathFIG-P1,P8 FIG-P3 FIG-P4 FIG-P5,P6 Routing the Lower Cable Lower CableAssembly instructions Assembly instructions Page Warranty WarrantyImportant Steps Important stepsTarget heart rate Your Target ZoneExercising Muscle Chart Muscle chartStretching routine Cool DownWarm UP Shoulder Lift Page