Evo Fitness 50551 owner manual Firmly tighten all fasteners at this time

Page 16

assembly instructions

ASSEMBLY

Step 10:

Attach the Pec Dec Support (16) to the Pec Dec Base (6) using two 1/2" x 3-1/8" Hex Head Bolts (71), four 1/2" Washers (89) and two 1/2"

Nylon Nuts (93).

Insert the axle of the Right Pec Dec Arm (10) into the sleeve on the Pec Dec Support (16) then attach with one 1/2" Nylon Nut (93) and one 1/2" x 1-1/4" Washer (88). Cap the 1/2" Nylon Nut (93) with one Cap For Nut (55).

Cap the Right Pec Dec Arm (10) with one 2" Round End Plug (51). Slide the Rubber Ringlet (68) onto the Right Pec Dec Arm (10). Attach one Elbow Pad (32) to the Right Pec Dec Arm (10) using two 3/8" x 1"

Hex Head Bolts (81) and two 3/8" Washers (90).

Repeat the same procedure for attaching the Left Pec Dec Arm (11) to the Pec Dec Support (16).

Firmly tighten all fasteners at this time.

-16-

Page 15 Page 17
Image 16
Page 15 Page 17
Contents EVO Sedona Home Gym Preassembly Before BeginningParts list Majority of the Listed Hardware is Already in PlacePlace Majority of the Listed Hardware is AlreadyADJ Cable Small Pulley Parts diagram By the FactoryAssembly InstructionsAssembly instructions StepAssembly Assembly instructions Detail TOP View Assembly instructions Bracket Assembly instructions Firmly tighten all fasteners at this time TOP Cable TOP Cable PathConnect Cable Path FIG-C1,C7 FIG-C3FIG-C2,C6 FIG-C4,C5PEC DEC Cable Path PEC DEC CableFIG-P1,P8 FIG-P3 FIG-P4 FIG-P5,P6 Lower Cable Routing the Lower CableAssembly instructions Assembly instructions Page Warranty WarrantyImportant steps Important StepsYour Target Zone Target heart rateExercising Muscle chart Muscle ChartCool Down Stretching routineWarm UP Shoulder Lift Page
Top Page Image Contents