Evo Fitness 50551 owner manual Bracket

Page 14

assembly instructions

ASSEMBLY

Step 8:

Insert two 1" Plastic Bushings (60) into the holes in the Top Frame (7).

Attach the Lat Bar Holder (14) to the Top Frame (7) using two 3/8" x 3" Hex Head Bolts (74), four 3/8" Washers (90) and two 3/8" Nylon Nuts (94).

Place the Top Frame (7) over the Guide Rods (22) and insert the Guide Rods into the holes in the Top Frame

(7). Align the mounting holes in the "L" bracket (welded on the Top Frame (7)) with the holes in the Upright (3) then attach with two 1/2" x 4-1/4" Hex Head Bolts (70), two 1/2" x 3" Hex Head Bolts (72), eight 1/2" Washers (89) and four 1/2" Nylon Nuts (93).

L-BRACKET

-14-

Image 14
Contents EVO Sedona Home Gym Preassembly Before BeginningParts list Majority of the Listed Hardware is Already in PlacePlace Majority of the Listed Hardware is AlreadyADJ Cable Small Pulley Parts diagram By the FactoryAssembly InstructionsAssembly instructions StepAssembly Assembly instructions Detail TOP View Assembly instructions Bracket Assembly instructions Firmly tighten all fasteners at this time TOP Cable TOP Cable PathFIG-C2,C6 Connect Cable Path FIG-C1,C7FIG-C3 FIG-C4,C5FIG-P1,P8 FIG-P3 FIG-P4 FIG-P5,P6 PEC DEC CablePEC DEC Cable Path Lower Cable Routing the Lower CableAssembly instructions Assembly instructions Page Warranty WarrantyImportant steps Important StepsExercising Target heart rateYour Target Zone Muscle chart Muscle ChartWarm UP Stretching routineCool Down Shoulder Lift Page