Evo Fitness 50551 owner manual Assembly instructions

Page 13

ASSEMBLY

Step 6:

Insert both Guide Rods (22) through the Rubber Doughnuts (57) and into the holes in the Base Frame (1).

Carefully stack the Weight Plates (12) one at a time by lifting them to the top of the Guide Rods (22), inserting the rods through the holes in the weights and slowly lowering each weight down.

Attach the Select Rod (23) to the Top Weight Plate (13) using the Top Plate Bolt (67). Slide the Top Weight Plate

(13)and Select Rod (23) onto the weight stack by inserting the Guide Rods (22) through the holes in the Top Weight Plate (13) and slowly lowering them down. Lock the Select Rod (23) in place with the Select Pin (66).

assembly instructions

-13-

Image 13

Contents EVO Sedona Home Gym Before Beginning PreassemblyMajority of the Listed Hardware is Already in Place Parts listMajority of the Listed Hardware is Already PlaceADJ Cable Small Pulley By the Factory Parts diagramInstructions AssemblyStep Assembly instructionsAssembly Assembly instructions Detail TOP View Assembly instructions Bracket Assembly instructions Firmly tighten all fasteners at this time TOP Cable Path TOP CableFIG-C3 Connect Cable Path FIG-C1,C7FIG-C2,C6 FIG-C4,C5PEC DEC Cable Path PEC DEC CableFIG-P1,P8 FIG-P3 FIG-P4 FIG-P5,P6 Routing the Lower Cable Lower CableAssembly instructions Assembly instructions Page Warranty WarrantyImportant Steps Important stepsYour Target Zone Target heart rateExercising Muscle Chart Muscle chartCool Down Stretching routineWarm UP Shoulder Lift Page