Clock
Your SpeedZone® Elite is equipped with a digital clock, which is accessed by pressing the "MODE" button for three seconds. The clock can be set to operate in either 12 or
Second Wheel Mode
For riders who own more than one bicycle or who frequently change tires, the SpeedZone® Elite is capable of storing two tire sizes. You can change between the two sized by pressing both the "MODE" and "FUNCTION" buttons simultaneously for three seconds. The second wheel mode indicator will change from 1 to 2. Mileage recorded will be cumulative between the two sizes. (An accessory handlebar mount is available from your Specialized dealer)
18
FIGURE 18: BATTERY INSTALLATION
INSTALLING THE BATTERY
Your SpeedZone® Elite Computer comes with the battery installed at the factory. Should you need to replace the battery, push the computer backward to remove it from the handlebar mount. Before removing the battery make a note of your odometer reading and wheel circumference settings so that you can
If the LCD display is blank or shows incomplete digits, turn the computer over and press the "AC" button on the bottom of the case with the tip of a pen or a paper clip. This will clear all the data and
TROUBLESHOOTING
•Display is blank:
Change the battery or press the AC button on the bottom of the case
•Display shows partial digits: Press the AC button on the bottom of the case.
•Speed/distance not recording: Check sensor/magnet alignment. Make sure that the sensor is no more than 1/16" (2mm) from the magnet.
•Entire screen is dark:
Did you leave the bike parked in the hot direct sun when it was parked? If so, move the bike to the shade. The data will be OK.
•Computer moves on handlebar: Tighten mount or add sizing straps to improve fit on handlebar.
19