
5. Selecting speed unit
Select the speed unit from “km” and “mile”.
1. Select the speed unit.
km ↔ mile: | M1/+ |
| M2/- (or) |
2. After selecting, press the MENU button. The measurement screen appears and the computer
6. Operation test
Test the functioning of the speed sensor (SPEED) and the cadence sensor (CADENCE).
*If the sensor signal icons, , and
are turned off, press the M1/+ or M2/- button to turn them on.
Speed sensor (SPEED)
1. Raise the rear wheel and spin the wheel.
2. | When | flashes on the computer screen and |
|
|
| |
|
| |||||
| the speed is displayed, it is operating normally. | |||||
|
|
|
|
| ||
Cadence sensor (CADENCE) |
|
|
|
| ||
1. | Turn the crank. | |||||
2. When | flashes on the computer screen |
|
| |||
| and the cadence is displayed, it is | |||||
| operating normally. |
*When or
does not flash, the position of the sensor and the magnet is not proper. Check and adjust the position of the sensor and magnet again (page 7).
Important: In the following situations, it is possible that other sensor's ID was picked up; (such can happen when performing ID Synch at the race venue or group rides)
• Does not display values, even though sensor/magnet position is proper |
Recommended Action: Go to the computer's ID Synch setup screen |
(page 23) and go through the process of ID Synch. (Make sure that here |
is no similar devices in the vicinity. Signal transition distance can vary |
Basic operation of the computer
Functions on the measurement screen
The measurement screen displays 4 different types of data, which are switched by press- ing the M1/+ and M2/- buttons.
The display data are as follows.
Upper display data
Displays the data related to the speed.
Middle display data
Displays the data related to the cadence.
Switch using the M1/+ button |
| M1/+ | |
Current speed | Average | Maximum | |
speed | speed | ||
| |||
Cadence | Average | Maximum | |
| cadence | cadence |
* Upper and Middle display data are switched in sync together.
Lower display data
Displays the other data.
Switch using the M2/- button
Elapsed time | Trip distance | Countdown | |
distance | |||
|
|
|
| M2/- |
| |
Total time | Date | Lap | Average | |
Total distance | Clock | lap | ||
number | ||||
speed |
ENG
from environmental conditions such as weather, buildings, etc) |
Sensor signal status
Real time lap data
Lap timer
If there is no incoming signal for approximately 5 minutes, the transmission stops
*Pressing and holding the M2/- button while displaying the lap
M2/-
M2/-
and no longer receive the sensor data. Once you press the M1/+ or M2/- button, the computer will come out of the Sleep mode and return to the
(flashing) : Receiving sensor signal | (constant) : |
(off) : Transmission off |
|
timer switches the lap timer to the lap distance. Pressing it again returns to the lap timer.
(2 Sec.)
Lap distance